top of page
RTV 3
![RTV3-transparent TDS.jpg](https://static.wixstatic.com/media/3721b0_00db7453604045f4a3f824b616aef1d9~mv2.jpg/v1/fill/w_866,h_480,al_c,q_85,usm_0.66_1.00_0.01,enc_auto/RTV3-transparent.jpg)
Operation Instructions
Step 1: Prepare the desired molds : Prepare a desired mold and clean it before operation.
Notes:
Make sure the desired molds and operation tools were cleaned up to avoid uncured problem. ( Suggest to use stainless steel or wooden material mixer. )
Step 2: Take amount Part A :100 g / Part B :100 g ( or Part A : 100 g and Part B :10 g ) and mix evenly.
Notes:
-
Weigh the two part exactly by electronic weight. If any part not in exactly weight, it may cause changing o of hardness, or even cause uncured problem.
-
Mix part A and part B evenly.
Step 3: Vacuum the mixed material. ( This step must less than 10 minutes. Otherwise, it will cause cross linking reaction, might cure too fast. )
Step 4: Pouring casting.
Notes:
-
For simple mold, just to pour the vacuumed material into mold, cured will be 8-12 hours.* For fine design mold, to brush the liquid silicone on mold surface then pour the silicone into mold. This will make the casing properly.
Step 5: Demold.
bottom of page